Quote:
Originally Posted by The Grizz
I don't get why the builder is laminating a 3" thick piece, I would have just used 3 - 1" sheets of plywood. Screw the first sheet to the top of the stand, 2nd sheet to the first and so on.
|
asylumdown didnt want anything drilled into the stand which i think he should allow at this point to help cut his losses. You could just drive a couple screws through the high spots in the plywood to bring them down level with the low spot. Screwing into the stand shouldnt create any issues. I had to do the same on my stand (all wood) to lower some high spots in a slightly bowed piece of 1" plywood.
next time have the builders aclimate the plywood to the house for a couple weeks and make sure it sits perfectly flat. "fresh" wood from the lumber yard will do all sorts of wierd stuff until most of the moisture has come out of it.