Quote:
Originally Posted by The Grizz
Is there any way to plug the lights into a power bar with a GFI type breaker to see if it happens? Did you try both GFI's with the troublesome fixture?
|
At first I thought I had a GFCI going faulty, so I switched the controller (Energy Bar 8) over to the other GFCI, and then the devices on the other one (power bar with Vortech power adapters, and reactor pumps, UV, etc) over to what I thought was the "bad" GFCI.
I wonder, could a poor connection with the bulb be causing this? Maybe they're not the perfect fit like the Pheonix bulbs, and could be arcing or something.
The funny thing is I experienced this issue weeks ago, and then one day one of my new Artemis bulbs died, so I put a pheonix back in while I waited for a replacement to be shipped out. And for that whole week everything was good.
And then this morning I put the newly replaced Artemis back in and all heck breaks out.
I think I'll have to maybe go with running the Pheonix bulbs while I'm away. The unfortunate thing is they're starting to grow cyano, so they're past their prime.
I wonder if I need to buy some reliable bulbs on Boxing day?
It's got to be one of these:
A. Bad socket or connection with the Artemis
B. Artemis runs differently which causes GFCI trip.
Before this whole issue, I've only ever had the GFCI trip once before and I'm sure that was because I dripped some water on the outlet while feeding.
P.S. I've resorted to using a paid monitoring service (30 day free trial though) to monitor my Apex controller web page. If the web page goes down, it calls my cell phone with an alert.