[Maverick00]

Well I tried various methods with no success. I got ****ed off and left it for a week. Friday i went back to rona and bought stain and polyurethane containers separately along with minwax brushes specifically for stain and poly. I conditioned the wood once again before adding the stain which (you guys were right) is a must. Then i applied two coats of stain using the method listed on the can. It worked GREAT. I then applied a coat of poly this morning, once again air bubbles appeared just as bad as the 2and1 i used previously. I thought for F sakes in my head, but as it dried the bubbles did get smaller. The poly is now dry and looks alot better than it did with the two in one. The finish is still alittle rough but with a quick sand and one more coat of poly im hoping it will lay even flatter. Ill try to get a pic and update after im finished, perhaps monday. So in my experience i wouldnt use the 2 in 1 again. Im not sure what i was doing wrong but i just couldnt get it together. I should say I am doing this inside (windows open) and my current tank is in the vicinity. I read air bubbles in poly could be caused by high humidity in the area of painting. This could be a factor..