Quote:
Originally Posted by Myka
You shouldn't need to add sodium bicarbonate to IO, but you will need to add magnesium and calcium! IO usually tests at 11 dKH for me, only 1150 ppm magnesium, and only 360-380 ppm calcium. My only real complaint about IO is the alkalinity is too high for my liking. I keep alkalinity in my reef 7-8 dKH, so if I do a big water change I get a big alkalinity swing. That was one of my main reasons for switching to H2Ocean. Even though the numbers of the H2Ocean are nicer I didn't notice any benefit in my reef after using it for 14 months. My reef is back on IO. I have tried most of the salts on the market, and I have never found my inhabitants to care which salt I used. That's the ultimate factor I think.
|
Thanks Myka for pointing out my mistake, ya I meant Mag not sodium bicarb lol..I have find IO to be fine as water change water. My Kh is at 8 and I have been using IO for the last 3 years. My issue is that the magnesium is constantly too low. I too have tried a few salts on the market from seachem to coralife and even a box of reefers best and IMO all my corals reacted the same so back to IO I went after you buffer everything of course. I find when you buffer IO with MgCl first followed by the calcium chloride the alk usually falls back down to 8-9kh range due to bi carb ppting out the calcium.
aftering buffering IO with mag chloride and calcium chloride with measured amounts in grams my weekly water changes come out to
Ca:440
alk: 8.5-9
mg: 1350
and thats for a salt that is less then $45 for a bucket