[CGY_Betta_Guy]

20101224 - One of the biggest complaints I have with the Fluval Edge in Calgary (being such a dry city for most of the year) is that water evaporation occurs at a very high rate. So I decided that I needed a solution to prevent such heavy evaporation from this SW tank. The solution I came up with protects my MR16 LED light bulbs from the salt water while also reducing the amount of evaporation that would occur from the tank. This is constructed from acrylic and a chunk of glass cut on a wet tile saw to fit inside the open mouth of the Fluval Edge tank.





This is attached to the existing arm in the tank and utilizes screws which go into nylon center nuts epoxied into the arm so that I can detach and reattach the lid at will.