Quote:
Originally Posted by Lampshade
There's small PVC valves on washing machings for the fill cycle, cheap, but only 1/2" opening.
Using a OM with a timer as suggested earlier would eventually give bad timing...BUT... you can do it without a PLC. Just get 2 adjsutable timers (like Panasonic PM4H), a relay, and a windshield wiper motor. Windshield wipers have a home sensor, or auto off switch. Most have them now unless it's off a 67 VW or something, i used a rear wiper off an aerostar for something similar, cost $10 from a wrecker. If you set timer 1 to run for 15 sec on (or whatever it takes to open). then off for timer 2 amount (your Open time). And On again to home position to reset timer 1 again.
|
I stay away from unreliable sources when I buy components for any OM unit, sure I can buy from E Bay, wrecking yards,and garage sales, but it isn't going to happen, I deal direct with OEMs for motors and magnets, the balance we produce in house, in the video provided. I am using the exact $39 timer I suggested a few pages ago, same principle that according to Mr Phelps would not work, I use an $8 sensor from Digikey to sense a magnet at each of four locations (home position)to trip the timer,reducing the number of magnets to just two would do exactly what MitchM required, the timer is set for around 7 seconds, it can be expanded to 8 hours if required.
http://s1008.photobucket.com/albums/...t=DSC_0263.mp4
Paul