Quote:
Originally Posted by whatcaneyedo
Center braces are a real pain to keep clean and work around. Maybe add some euro bracing for piece of mind though.
What tool did you use to cut the coast to coast overflows? Got a picture? Great job by the way. I wish I had more experience with glass so that I could contribute but so far I've mostly only played with acrylic and wood.
|
Thanks. I just went to princess auto and in the carbide burr/diamond hole saw/diamond burr bits isle in the back near the air fittings there are diamond blades for your dremel. They were a whopping $8.99 for 4. I used the pencil attatchment as I had the wife holding the hose for constant water flushing and cooling and well a dremel wont handle the water. Didnt take long. I need to get the diamond burr set too for $10 to round the corners and clean up the edges. If i do anymore Id suggest going almost the whole way through and then meeting on the other side as I had a little bit of chipping happening when I went all the way through one side. Ill snap a few pics of the tools and such here tonight.