Quote:
Originally Posted by MitchM
Electrical plug-ins were at a premium and I needed 3 for a calcium reactor. 1 each for recirc pump in the reactor, supply pump for the reactor and 1 for the solenoid. With a dosing setup I only need one plug-in for 4 dosing pumps.
|
That's a good point. I had forgotten how much of an irritant the mess of electrical wires was no matter how "tidy" I tried to make it.
Don't get me wrong: I dose. I sold my reactors and my spare cylinders and regs, just kept one of each and threw them on my FW planted tank. For two years or so I never looked back. I can't bring myself to pony up the $300 or $400 for a multihead unit, but I'm using the smaller single head units and other than the increased time to figure out an ideal timing cycle it's been fine enough.
But as I stare at my empty dosing reservoirs and think "Man, I need to refill those" I am fighting an overwhelming sense of "UGH." 1) Didn't I just do that 2 or 3 weeks ago??? 2) Geeeeze it's a messy job. If I don't have any prebaked baking soda, I go get a couple boxes, spread them into a cookie sheet and bake it for the required hour. Then I go get a gallon or so of RO/DI and put it into a kettle. Because the baked baking soda is roughly as soluble in water as silica sand, and mixing it in hot water helps a tiny little bit. So then I take my prescribed amount of baked baking soda, 2 and a bit cups, and then I have to add it to the water about a teaspoon at a time, mixing for at least 10 seconds in between. 2 and a bit of cups divided by teaspoons equals approximately a billion. If I add it any faster or in any larger amount at a time, it does one of either two things: 1) Clumps together rock hard and becomes completely insoluble, or 2) the entire mixture congeals into a gel like substance and the only way to reliquidify is to add more water to the mix (other than it's a complete PITA because I'm trying to mix my alk additive, it's actually quite a bizarrely interesting phenomenon). Anything that spills make a huge mess because wet baking soda is just messy like that. So my alk mixing is at the very least about a hour commitment, more if I have to prebake any amount.
Calcium is nowhere near as bad but it makes a brown gross slimey liquid so the reservoir at the very least needs cleaning in between fills and I wonder if I should be purging my 1/4" lines periodically as well because it stands to reason they'll be covered with that residue as well over time.
I mean, seriously, this is the "better way to dose" ?? I don't think so. Before I started using the peri pumps I just took my powdered additives and mixed up enough each day to dose that day's amount. THAT was really the "best way" for me as it was nearly effortless but the problem is it's really difficult to automate the process.
I'm using Chemmaster for the Calcium and Magnesium and just baking soda from Costco for the Alk. Maybe it's time for me to step it up and start buying from BRS or other places because if this process isn't normal for everyone else then there's something wrong with what *I'm* doing and I can't really see what I'm doing wrong procedurally so that really leaves, by process of elimination, the ingredients themselves that must be the difference.
I'm all for hearing suggestions on how to make this mixing process suck a little less..