Oh trust me, I would love to be singing the praises of the Apex just as you guys are. It was all the positive feedback that helped me make up my mind to buy it. After my little rant yesterday I decided to reinstall the firmware and reprogram everything and as of this moment everything seems to be holding steady and the controller has not changed the address of EB8. The only issue remaining appears to be switch 8 which is my Alkalinity, is not working. Switch 4 (calcium) is working fine and the icon does indicate that switch 8 is enabled, it just doesn't come on. I tried my dosing pump on a live outlet and I know it works fine. I tried to do the "manual on" and no luck. I'll still have to give Neptune a call. One thing I have noticed is when I go into the Module Setup, it shows the EB8 module as "OK" but the Display Module is "Old". Is this typical? The other thing is the display slows down drastically and speeds up for no apparent reason when navigating the through the menu on the display module. I suspect this is because the processor is busy executing a command but that's just a guess.
|