i have officially come across my first hurdle in this build. the tank has a inset border around three sides my assumption was that it was to hold a lid inside the tank. now i was hoping that the builder only siliconed the edges not the flat to the glass.. my hopes are now crushed.
so now i have to figure out how im going to separate these pieces of glass from the tank or its going to look like crap so far i have tried razor blades thin screw driver but it seems like it was clamped tight and no room to slowly peal the silicone off. i am thinking my only dangerous option it to chip it away untill im able to scrap the rest off. or leave it be and build a trim to cover the ugly. if you have any suggestions or ideas it would be appreciated. i really would like to remove it if possible.
