[globaldesigns]

Originally Posted by Delphinus

It looked like somehow I was getting an air bubble trapped under the bottom sponge. I finally managed to get some quilting mesh a couple days ago, so I took the opportunity last night to replace the bottom sponge. Also I was running spongeless on the top already, but every so often the reactor would burp and I'd get a few pellets into the sump (and sometimes all the way up to the display tank) so I decided to put a top layer of the mesh in as well.

The MR-1 isn't as nice of a tumbler as the Vertex because of the bottom plate design (have now seen both reactors in action so have a fair basis of comparison). The MR-1 has a circular/slotted style openings and it seems that this causes an uneven upward flow whereas the phosban reactors and vertex have drilled bottom plates. I think this does make a difference so I think I will be at some point switching to a Vertex instead.

Rick - actually at some point I'd kinda like to see what the Deltecs look like in action as well. Maybe someday I could show up with a coffee or something? What's your favourite Timmie's concoction?

So.. anyhow, another update. I finally finished pulling the trigger on the zeolites last night, after removing them about 250ml at a time every couple of days for the last week. In the spirit of wanting to increase the pellets at the same time to compensate for any potential loss posed by the zeolites removal, I put my phosban reactor back on, so I can have two reactors running pellets now. I bought an Odyssea pump from Red Coral on Friday, put that on the MR-1, and switched over the MJ12 to the phosban. Only I took the sponges out of the phosban and put the mesh in there too. WOW, does that ever work awesome. Between the bottom plate difference and the sponge removal, the pellets are dancing like berserk in the little reactor.

So now running close to 2l total.

You can come over anytime, Yum, timmies Iced Cap. I work from home, so anytime will work.