I don't really mind the electrical not passing. Even though part of it not passing was simply my misinterpretation of what constituted "ready" and part of it was "Ok I have to redo some of it", the list is not that bad, won't take me more than a couple days and after that it will all be to code.
What irks me is the plumbing. I plan to put a bathroom downstairs eventually but finances being a problem these days, my plan was to sit on it until well into the future. But since taking time off work to go to city hall and all that is a hassle, I decided to get the permit now and be done with it. I *thought* all I needed to show for the plumbing to get passed was just a "rough in" - roughly, the water comes from here..and roughly the water drains into that pipe there. The bathroom has a toilet and sink rough-in already but only one capped-off T. I was just going to T into this stem for the bathroom sink and mini-kitchen sink that sits on the other side. But it turns out that this isn't good enough, I need to rough-in BOTH T's for the sinks. Ok, no big deal there either: a hacksaw and $10 worth of ABS and ABS cement and I'm done.
The tank room sink is what really has me choked. Never in a 100 years did I anticipate I was going to be failed based on a laundry sink that I use to rinse a protein skimmer with because it drains into an existing floor drain. What has me doubly-choked on the whole thing is that when I built the house, I ASKED FOR A SINK ROUGH-IN. Between my cost-sensitive spouse and a housebuilder's sales lady who was doing her best to keep our build costs under control, I was out numbered and this option was struck from the list "because the floor drain is good enough." So the cost for saving $100, 6 years ago, is now today I have to foot probably about $1000 bill to have this work done. Even if I were to do it myself it will be HUGE pain to route a vent through the ceiling trying to work around HRV and furnace vents and who-knows-what just to tie it into the nearest pipe stem that's vented all the way up to the roof.
I'm just incredulous when I think of it. I thought it would all be about how the lines tie in and any issues with pipes pressing up against nails or whatever that could cause a leak. In the end, he couldn't have cared less about the supply lines. That part of the inspection was done in less than a minute and it was all fine. It was the drainage that he was all incredibly anal about and really the inspection was done in 2 minutes because he just ended it when I told him the tank room sink was draining into the floor drain. He was in and out in less than 5 minutes. And I had to take a day off work and sit at home and wait for 8 hours for that 5 minutes that ended so rather dissatisfactorily. I am NOT HAPPY.
I am giving serious consideration to "officially" removing the laundry sink from the plans.
With the electrical - everything - I understand there's a safety issue. After consideration, I fail to see the safety issue of a laundry sink that drains into a floor drain. Is the concern that the pipe could get kicked loose and water drains onto the floor? Is that any worse than tripping while carrying a bucket full of water?
I don't know. It's not the sort of thing I dare to say "I told you so" to my wife but at the same time I'm really annoyed with myself that I didn't stick to my guns back then.