Quote:
Originally Posted by imcosmokramer
those are cool zoas
|
Thanks! Your little sps cube is kind of an inspiration for my future plans with the tank add on. so simple and clean looking, really makes the colours pop.
So here is my DIY sump holding water!
24.5 X 18.5 X 15 are the dimensions. the baffles adjust the water level to about 10.5". As i said before i am a little bit nervous about using this due to the fact that i didnt really have the right tools for the job. all cuts were made with a dremel, sanding the edges smooth was also done with a dremel. really smoothed them out with some fine grit sand paper. taped it up and used weld on #4 and #16 to seal it up. right now it have placed it over some cardboard and filled it with water to check for leaks. so far so good. this would be a lot easier then using the biocube as i have thought on previously, I am just not sure i trust the build quality
