View Single Post
  #5  
Old 01-12-2010, 04:28 PM
mike31154's Avatar
mike31154 mike31154 is offline
Member
 
Join Date: Jul 2008
Location: Vernon
Posts: 2,073
mike31154 will become famous soon enough
Default

Ok, I'll be the fly in the ointment here. I'm also not a fan of carpet but dislike laminate even more. Hold out and spend a few extra bucks for hardwood and perhaps tile for under the tank. I know it's a mobile as you mentioned and you won't be in it forever and you're on a budget etc. Look around for deals, you could probably get some half decent hardwood for 2 to 3 dollars/sq ft. Might not be the best stuff for that price, but it's so much more solid than laminate and can always be refinished, a number of times if needed.

I'm in the midst of flooring renos as well and have pulled most of the carpeting in my place. I managed to score sufficient hardwood for most of the rooms at auctions held by an auction company from the coast that swings by Armstrong and Winfield from time to time. I think most of it comes from China, but I don't care, it looks fine and the price was definitely right.

My problem is, I'm slow but like to think I'm thorough. Things aren't getting done in a hurry, the living room is mostly done and I actually screwed the planks down instead of using a nailer. This meant pre-drilling and countersinking holes for every screw used to hold the flooring down. Also, since the planks I used in the LR are all the same length, I decided on a double herring bone pattern for putting them down. This meant I had to cut off the tongues and route a groove into the end of every few planks and cut plywood strips as tongues for the ends of the grooves that mated to these. A ton of work, probably anal, but the end result is worth it.

Here are a couple of photos. Actually the under floor electric heating I put in for under tile at the bay window, but you can see part of the hardwood as well.




__________________
Mike
77g sumpless SW
DIY 10 watt multi-chip LED build http://www.canreef.com/vbulletin/showthread.php?t=82206

Last edited by mike31154; 01-12-2010 at 04:53 PM.
Reply With Quote