Quote:
Originally Posted by howdy20012002
but the 2 x 10 have no where to go....they are completely supported by the retaining wall below them...they would basically have to be crushed for them to go anywhere or the retaining wall would have to be pushed down.
as well the the retaining wall will be dead centre of where the tank is going to be above it. so the tank will be stradling the wall.
as for the stand ends, I woudl be running a 3 x 3 beam along the bottom of the stand along the floor. that way the weight will be dispersed along the entire length.
|
The beam at the bottom helps a bunch. I was under the impression this would be point loaded at the feet of the stand. If you can truss the bottom beam into the uprights, that will help keep the load spread out. I would also still suggest putting braces in between the joists immediately below the tanks, to prevent them from buckling sideways.. especially near the retaining wall.
would love to see some pics of the setup when its all together.. sounds like quite the operation.