[StirCrazy]

Originally Posted by Myka

I'm a total halide fanatic, but I wouldn't run halides on an LPS tank. Too much light, plus you pay only a little less for a 150w or 175w halide bulb as you do for the higher wattages, so it just seems a waste. If I decided to make my tank LPS dominant again I would sell my halides and get T5s. I had an LPS tank recently that ran very well for 2 1/2 years with T5s. Most people would be surprised how little light LPS need in order to thrive. Many people over light them, and when they cut back lighting they experience much brighter colors. Besides, the T5 bulb choices give you lots of options for "color cheating".

this is kind of a grey area, MH is not to much light for LPS, but if you were using T5's for a long time they will take a while to adjust. look at the reef around austrailia and haiwii, there are LPS in 5 feet of water which are reciving more PAR than we could ever dream of putting in our tanks. the problem is most people don't have enough flow in there tanks to prevent/minimize bleaching. I have done exparaments after reading a few articles on bleaching and water flow and which a low flow rate of 20X turnover I could bleach the heck out of frags, but when I increased the flowrate to 120X I couldn't get them to bleach at all with all other conditions being the same.

now just increading pumps isn't enough, the trick is to spread the flow out all over so it ends up being a gentle current not a jet wash, I had a 94 gal tank with almost 12000 gph flowing in the display, but you could put your hand anywhere and all you felt was a gentle flow.. it took me about a week of screwing around with placment and such and I don't think you would ever acheive this with a sand bed (as the flow on the bottom of my tank was the same as the middle and the top) and you may have to be willing to rearange your rock to give you the best flow not the best look, but you could probable achieve both with a little more paitents than I have

Steve