[StirCrazy]

Originally Posted by Dez

Hi,


Cutting - the easy part. Go to a stain glass shop and get a glass cutter (dont' get the cheap home depot scribe one - I've had less successful experiences with these as it's a scribe and not a wheel). You can get a nice glass cutter for under $20 at a stain glass shop .

you can save a lot of money going to home depot and buying a wheeled cutter. personaly I have never seen a drag scribe for glass.

if you do not buy one with an oiler make sure you use a bit of oil on the cutting wheel.. dip it in and then shake it a little. if you are only doing a small bit of cutting don't waist money on the tungston carbon wheels just get the regular hardened steel wheel and you will be looking at about 8 bucks. I used a bit of air tool oil as that what I had laying around but any light weight mineral oil will work.

I never used a wire wheel or brush when I did mine, just scrape with the razor blades real good till you can't see any silicone then I used acatone to clean any residual stuff off. the problem with the wire wheel or brush is you have to be very very carefull not to put any scratches in the area you are cutting as there will be a chance of the cut following the scratch instead of the cut line.

if it is going to be a critical cut use a strait edge to guide your cutter and start off the glass and continue to cut till you run off the end and no stopping along the way. it has to be one long fluid cut using constant pressure or you can cause chipping int he glass which can cause your break to run off instead of staying true. not as hard as it sounds.. I did a curved one free hand and it worked pretty good.

Steve