Quote:
Originally Posted by dbdavid
Basically you kneed the epoxy together.
Dry off the spots where you want to glue.
Place a generous amount of the Super T on one end.
Put a piece of epoxy over the Super T glue.
Place some more Super T over the epoxy and then put the two pieces together, hold it for a couple of seconds and you are good to go.
While placing a frag underwater you must hold the frag for a little longer. I put a lot more Super T on it than I would if it were dry as it starts to set as soon as it hits the water.
Dave
|
I have been having a heck of a time with some frags that my urchins continue to knock off. I never new you could use super glue under water. But I will try anything at the moment.
I will test this tonight.