Well a little update, our Skunk clown died. He got sucked into the Maxi-Jat 900 intake and I wasnt sure how long he was in there for. I pulled him out and he was walking on the bottom but when I went back 15 minutes later he was back in the intake dead. I will replace him but not until the big tank.
Speaking of big tank planning has been put into effect. We have decided 48Lx30Wx24H. We werent planning on going that high but we have decided on a Vortech MP-40 for a wave effect. Lighting we still are not sure about still undecided between 250W MH or 12 T-5's We want clams and easy to keep SPS this is why we have decided on so much light.
Here is the tank that inspired the new build. Its tmantaylor18's tank on RC
We have decided to go a little longer than that tank but am keeping the same depth. Actually be be 100% honest we are throwing around the idea of going 36" deep instead of 30". I really like the deeper tanks over the more narrow ones.
Well here are some pictures that were taken tonight. As always the clownfish was easy to photograph but the flame was a little leary and the wrasse isnt too bad when the Flam isnt chasing him around. Poor little guy.
6 Line Wrasse
Hammer Coral Frag
New Sprouts
Fish and Inverts
Full Tank Shot
Unknown Anemone that just showed up
