[Gizmo]

Ok, now i remember web code This is Kai.

and Kristi

The Control Board

Dart Pumps

Sump

Plugs for the monitor hardware.

The 1 GFI handles all the plugs. I hate using GFI plugs on "mission critical" hardware, nothing worse that being on holidays and for whatever reason, the GFI trips and shuts down the heaters or pumps.

This is 2 of the feeder junction boxes on the ceiling above the sump. The wires hang down with a cord cap on the end to plug the devices in. Keeping the plugs suspended eliminates any worry of water getting in, or at least sitting in the plug.

Left: Main tank ballasts for the 3x400w MH. Right: more junction boxes

Here's the front of the sump. The line at the bottom is for draining the sump for water changes or service. It is connected to a drain system that goes around the whole mech room, i'll show some pics soon. The toilet tank is my DIY wavemaker.

Ozone dumahiky, and nitrate, ph, calcium and salinity monitors

Here is my old display tank. Its now a fuge. 70g worth of fuge.

Here's the backside of the display tank. The light is on a suspension rig, so I can raise it up for feeding, servicing, etc. in its lower position it sits just mm above the rim

Left is the Venmar 3100. It sucks in air directly from this room to dehumidify, clean and expel bad air. Nice piece of kit. On the Left is the breeder rack. it has 2x 250mh lights and is/will be plumbed into the sump.