T5 DIY planning.
Now, I'm not the best DIY'er but I am always up for trying something if its gonna save me some money (especially on a low budget build).
Ok, So I am pretty sure I have figured out what I wanna try for my lighting on my 40G cube.
I was thinking of purchasing 2 - Aquamedic 4x24W NO T5 units (getting a good deal), tear them open, DIY to brace them together as one unit, therefore creating a 8x24W unit cheaper than anything I can find. I was then going to pull out the single reflector and NO ballasts, and swap in Tek individual reflectors, and run 2 Workhorse 3 HOT5 ballasts and 1 Workhorse 5 HOT5 ballast. Bulb configuration (and proposed light schedule) as follows.
Ballast #1 and #2 are the Workhorse 3's
Ballast #3 is the Workhorse 5.
Giesemann 10K (Ballast #2) (On: 1000 Off: 2200)
KZ Fiji Purple (Ballast #3) (On: 1100 Off: 2100)
Giesemann 10K (Ballast #3) (On: 1100 Off: 2100)
Giesemann Actinic+ (Ballast #1) (On: 0600 Off: 2400)
Giesemann Actinic+ (Ballast #1) (On: 0600 Off: 2400)
Giesemann 10K (Ballast #3) (On: 1100 Off: 2100)
Giesemann True Actinic (Ballast #3) (On: 1100 Off: 2100)
Giesemann 10K (Ballast #2) (On: 1000 Off: 2200)
Now my main concern after all that........ Is there an easier way to set this up??
|