we have tested them to 50'.
So as you have said, set up your dosing tube run and then calibrate
4.3 Calibrate
Our pumps have an average flow rate of approx. 60 ml/minute. If a pump has a deviation caused by tolerances this can be
entered in the menu Calibration. First you have to select the pump, and then you can enter the Flow rate of this pump.
In order to find out the actual flow rate do this: Activate the pump manually for exactly one minute and measure the amount
which has been pumped during this time.
Hint: The set flow rate does NOT change the actual performance of the pump (it will always run with the same speed)!
The set flow rate is used by the controller to calculate the on-time based on the desired dosing amount.
|