Step 1:
Make sure the cord is long enough to reach from the electrical outlet to the place where you plan to use the drill.
Step 2:
Use the chuck key that comes with the drill to open the chuck. Do this by pushing the nubbed end of the key into a hole along the chuck and twisting counterclockwise. The teeth on the chuck key should engage the ones on the drill.
Step 3:
Insert the a small drill bit into the chuck and tighten it with the chuck key, turning it clockwise this time. Be sure it's very snug.
Step 4:
Plug the drill in.
Step 5:
Press the trigger before you make contact with the work.
Step 6:
Slowly touch the tip of the bit to the work and apply steady but light pressure.
Step 7:
Maintain the pressure on the drill and the trigger until the hole is completed.
Step 8:
Keep the trigger depressed as you slowly back the bit out of the hole.
Step 9:
Place a square bit in the drill by doing step 3 in reverse before redoing it with the square bit.
Step 10:
Screw the pieces together... maybe add some glue??
ahah
|