Thread
:
Acrylic Router Bits
View Single Post
#
4
06-27-2008, 01:52 PM
sphelps
Member
Join Date: May 2006
Location: Lyalta, East of Calgary
Posts: 4,777
I use a jointer for gluing surfaces, however a router should work fine with any carbide bit. Perhaps you're removing too much material? I usually only remove 1/32 or 1/16 at the most. Also feed rate and router speed is fairly important.
sphelps
View Public Profile
Send a private message to sphelps
Find all posts by sphelps