Quote:
|
The base looks a little weak in holding all that water.
|
:?: :? :?: :? :?: :?
Holding all of what water? Weak? Lost me here. Explain Si vous plait.
Yeah it is a Ca reactor. Put it together tonight for something to do. Plumbing completion TBA.
Quote:
|
That middle piece looks like it was cut on a bit of an angle
|
Well I guess the guy who cut it would notice those imperfections and flaws.
For those who haven't put it together it is a up-flow/down-flow reactor in one. The 'H' shaped PVC widget is where the water is pushed into the reaction chamber transiting up over the middle baffle(cut on an angle if I may add) and then down through the right hand side into the pump intake. There is a thin diameter piece of tubing next to the baffle which will be connected to the effluent outflow. It runs all the way to the bottom of the reactor just prior to the outlet to the pump to ensure the minimum possible CO2 leaving the reactor after passing through both the up and down flow of the reactor.
By having the upflow then downflow any particulate matter created by the rubbing of the media will be trapped in the downflow section of the reactor and the foam pad that will be on top of the drilled section of acrylic(strainer).
Once the main plumbing is completed and I can pressure test the whole thing I will load it with media and water then find where any possible collection of CO2 will occur. When I find this spot I will insert a recirc line which will then 'T' into the CO2 line and then into a small venturi I am building to ensure some suction drawing any excess CO2 back into the pump with the CO2 feed.
Plain as mud. Right?