[Aqua-Digital]

Hi,

Ok baby steps, lets break this down into parts for you.

Firstly, you would be wise to go for the connect pack as this already has LAN in it and will save you a lot of money, unless of course there are parts in it you do not require, then it would be wise to build your own system pack as you require.

Moving onto Tunze cables.

To run two tunzes you require a YL2-1 splitter cable that plugs into L1/L2 and splits the port, you then require Tunze1 and Tunze 2 cables, you cant use anything other than GHL supplied western adapters as the wiring is unique to both Tunze and GHL. With regards to cable length, up to 5 meters is available.

The LED you have chosen is fine and will plug straight into L3 L4.

If you require dimmable lighting, you will need to split the L3 L4 port with another splitter cable.

The part number for the dimmable interface with zero volt shut off is EVG-AP-2F

Wiring is striaght forward. the dimmable ballasts come with a 1-10V control line, this is just twisted pair wiring,, take the pair from the ballast and wire into the EVG card, and then plug the supplied western cable into the EVG card and Profilux. The power for the lights then is wired into the EVG card also and power for this card must be from a constant source.

It may be worth getting WLAN now if you are even contemplating going down this road it is cheaper now than later.

The profiview attaches to the back of the profilux via the RS232 cable

Let me know if I have missed anything

Regards
Michael