Finally getting to setting this thing up...
OK, so far my experience has been good, I think the controller has a lot of potential, but I am just getting started setting it up. I have the following questions:
1. According to the manual, there is a "fitment" available for attaching the controller to the wall..."Using our optionally available fitment the unit can also be attached to the wall." Can anyone tell me where to get one of these?
2. I continue to have problems displaying a graph of readings. I have updated both the software and the firmware to 3.03. I don't seem to be able to see any readings on the chart.
3. I have heard about the Redox / Salinity Conductivity Expansion module and would like to get more information how it works and what it does. Do you have a brochure at all with more detailed information?
I am going to go through the manual again and I'm sure I will have more questions. Thanks in advance for your help.
Cheers,
Gord.
|