Thread: Raising PH in the reactor, and EM problems with Controller
View Single Post
  #1  
Old 01-02-2003, 10:52 PM
Jboy Jboy is offline
Junior Member
  
Join Date: Jan 2003
Posts: 14
Jboy is on a distinguished road
Default Raising PH in the reactor, and EM problems with Controller
Hi everyone,

My Canreef reactor is up and running nicely, with my bubble count being around 8/min, and the effluent rate at 30 drops/min. The PH is around 6.7, but according to the ARM media, It should be a bit higher. What is the general opinion on the best way to do this?

1)Lower bubble count
2)Raise effluent drip rate.

Thanks,

Also, I seem to be getting some rather bad Em interference with the modules on the my Aquacontroller II. Any module that is near my atinic ballast does not work. Also, it seriously messes up the temperature probe. Any one else have this problem?

Thanks, and have a great new year everyone

Jason
Reply With Quote