Wlan
Lam, lets do it step by step.
You first need to properly set up your RS232 connection. And this is described in 10.4 in the profilux manual. So with this you should be able to set all parameters (COM-Port on your PC where the RS232 cable is connected and the 9600 baud rate) of the RS232, and then connect to your Profilux. Can you confirme that you have at least the RS232 connection running? If you have a working connection you will see the menue on the left side and have then accsess to all functions of the Profilux.
Second you need to understand the IP network system and for this it is best that you again read the chapter 1.2 of the WLAN instruction. The IP of the WLAN card must be in the range of your network, but can not be the PC or the Router adresse. Can you please write down the IP of your PC and the one of your Router? So then you have to choose one who is free for your WLAN card. Write it down for us so we can see what your are doing. Do not choose a IP adress who is occupied by other network equipment eg. printer etc.
|