View Single Post
  #365  
Old 04-19-2007, 11:31 PM
Ginzo Ginzo is offline
Member
 
Join Date: Feb 2007
Location: Montreal, Canada
Posts: 44
Ginzo is on a distinguished road
Default

Hi Matthias,

I've been trying to figure out how I could do the following, but I haven't had any success so far, maybe you can tell me if it's possible (since I think in the current state it isn't)

Here's what I want to do:

1) When float switch (1 sensor) is activated (maximum level attained), I want it to stop my pump (water1) and activate the alarm (buzzer, it would be great if it could also send me an email).
2) When float switch (1 sensor) is not activated (normal level of water), I want my pump running (water1) permanently.

Currently, I have only been able to program the following via the PC software:

1) Set to min/max operation mode. Water 1 is permanently on. When max is attained, water 1 is permanently off. I have no way of knowing it's has been shutoff (no email, no alarm or buzzer). The only way I know it's off, is if I check to see the pump is running or not.

This operation mode will prevent me from having an overflow, but it would be great if I could achieve the scenario I described earlier.

Let me know what can be done !

Thanks,
Chris

Last edited by Ginzo; 04-19-2007 at 11:36 PM.
Reply With Quote