Dried pH probes
Pretty sure it was here I had seen a post that if a pH probe dries out is toast.
Was reading through a manual for the Milwaukee SM102 and under the Operation notes is: "If the electrode has been left to dry soak the tip (bottom 2.5cm) in rinse solution (M10000B) for a few minutes to reactivate it."
The manual doesn't get into if the probe has been sitting dry for a year or an hour and if it applies to other manufacturers, just though I'd pass along though.
btw, MB100000B looks to be deionized water.
Last edited by mark; 03-19-2007 at 11:58 PM.
|