View Single Post
  #5  
Old 01-16-2007, 06:28 PM
howdy20012002's Avatar
howdy20012002 howdy20012002 is offline
Member
 
Join Date: Nov 2005
Location: Edmonton
Posts: 1,437
howdy20012002 is on a distinguished road
Default

Step 2
I basically had to come up with a way to connect the hose to the inside of the cap so that it would stay connected
I tried to glue it together with crazy glue, but apparently air hose and the quick connect valves don't like each other.
what I came up with was have the valve on the inside of the cap instead of the top of the cap. I then drilled out just enough of the inside of the valve so that the 1/4 inch airhose could go completely through the valve and out the top end of the cap.
I basically used a 1/4 drill bit and just slowly drilled out the valve.
Make sure that you go in the direction that the air hose will be going so that it dosn't push out the inside of the valve...IE, go in the direction of the valve.
__________________
Way too much time and money has gone into this hobby....and yet, I CAN'T STOP
Reply With Quote