Hi Colin,
thanks your comments above.
Tunze control:
i don't know your configuration, i guess you connected 2 pumps with the cables ProfiLux-Tunze1 and ProfiLux-Tunze2, these 2 cables are connected over an Y-cable to one 1-10V-port of ProfiLux.
Further i guess this is port L1L2, then these settings should be done:
1. assign the function current pump1 to 1-10V-interface 1, set min-voltage to 3V and max-voltage to 8V
2. assign the function current pump2 to 1-10V-interface 2, set min-voltage to 3V and max-voltage to 8V
3. do the other current settings as needed (mode, percentage, times,...)
WLAN
i don't understand why you can't get it running. In earlier posts you wrote you had connection until you set the settings to factory defaults. So you have been very close to the target... Try it again next weekend...
Redox and all your other problems
seems you could solve them finally
In general (for all users): ProfiLux is a complex device with a lot of features. It has about 1000 settings which can be altered. We tried to develop a mostly self-explaining user interface but it is strictly recommended to read the manual completely and accurately (even if you think it is not neccessary because you think you'll guess how to do the configuration), only then you will be able to get the most benefit from the manifold features.
And if there are still questions ... don't hesitate to ask me for support!
Last edited by Matthias Gross; 01-10-2007 at 05:54 AM.
|