Quote:
|
Originally Posted by Delphinus
Albert has some great advice. The one point I might challenge him on is his recommendation for 1.5" holes for the overflows. Standard schedule-40 1" bulkheads require a 1.75" hole, IIRC. I'm pretty sure I've never seen a 1" bulkhead that would fit in a 1.5" hole. Schedule-80 bulkheads exist too and they require an even bigger hole. Unless he's thinking of smaller bulkheads?
I have a 1.75" drill bit for glass that you could borrow if you wanted. Drilling glass isn't too bad, I've done it many many times. I could help you out if you wanted.
|
I meant 1.5" ID on installed bulkheads. I totally forgot about the bulkhead sizing. The holes should be 2" to accept 1.5" standard ABS bulkheads (IMO, PVC bulkheads are excessive since the sytem is not under pressure). But yeah,thanks for the spot Tony.