View Single Post
  #37  
Old 06-17-2006, 08:58 AM
albert_dao albert_dao is offline
Good Guy Albert
 
Join Date: Jun 2004
Location: Richmond
Posts: 3,035
albert_dao will become famous soon enough
Send a message via MSN to albert_dao
Default

Since this tank is frameless, you'll want the center of the tank to "float". The reason being that, under pressure, the glass will push down against the floor support, with the floor support exerting an equal amount of pressure back against the glass (physics, lol). If there's ANY kind of uneveness against the glass (eg. a knot area in the plywood), it's going to create different areas of pressure; foam will only provide a marginal buffer against this. Imagine pushing the end of a 2x4 against the center of the front panel, it'll just break. The same applies to your bottom panel, except tenfold since that's where all of the weight is concentrated.

For this reason, Oceanic will not warrantee cracked tanks that are not put on Oceanic stands. These stands support only the outside edges of the tank, thus, floating the center.

Edit: you're going to want to go back to Home Depot and pick up some of the 3/4" hard foam insulation sheets for this. Soft foam is just asking for it...
__________________
This and that.

Last edited by albert_dao; 06-17-2006 at 09:02 AM.
Reply With Quote