Thread: Where do you get your bulk heads from?
View Single Post
  #11  
Old 04-22-2002, 01:38 AM
Delphinus's Avatar
Delphinus Delphinus is offline
Member
  
Join Date: Dec 2001
Location: Calgary
Posts: 12,896
Delphinus has a spectacular aura aboutDelphinus has a spectacular aura aboutDelphinus has a spectacular aura about
Send a message via MSN to Delphinus
Default Where do you get your bulk heads from?
Hmmm. If ID is 1.5, then ... wait a minute ... that does sound a little odd. Aren't PVC pipes measured from ID? So what has a 1.5 OD measurement, is that 1-1/4" PVC maybe? But Revy had nothing that would fit? You're just comparing it to the pipe itself, right, not the fittings (unions couplings etc.)?

Hmmm, I'd almost be going back to Big Al's and ask them what you're supposed to use on this bulkhead they sold you. It isn't supposed to be complicated!

The last few bulkheads I've worked with have all been for 1" PVC. The hole they need drilled is approx. 1-3/4", but the threaded end takes 1" PVC threaded male connectors, and the other end I can just jam a 1" PVC pipe in there and it's a snug fit.

:confused:
Reply With Quote