Thread: Heatsink
View Single Post
  #13  
Old 03-20-2005, 04:55 PM
AndyL's Avatar
AndyL AndyL is offline
Member
 
Join Date: Oct 2004
Location: Beiseker
Posts: 900
AndyL is on a distinguished road
Send a message via MSN to AndyL
Default

Yes, the plan was to use it as a place to mount - and source of heat removal (maybe not the brightest idea exposed wires and aluminum and all - but I figure I can use some liquid electrical tape where needed and make things safer)

Drilling the acrylic, it seemed like if I breathed wrong i'd end up with a nice crack running from hole to hole to hole.... Of course, I would probably have had better success with a different bit, and the use of some lubricant. But hindsight and all...

Andy
Reply With Quote