the led will only draw as much current as it needs. As long as the supply is capable of supplying it. In your case then, no limiting resistor is required. However I would double check the voltage of the LED 'cause most LEDs are only 2 to 5 volts.
What you do, if you dont have a nifty website calculator handy, is take your total supply voltage and subtract the voltage "used up" or dropped across the LED and then divide by the current (in amps) to yield the value of the resistor needed. when looking for a suitable resistor always round up.
ie. 12v supply, 2v 10ma led
12-2=10 10/.010 =1000
so a 1k ohm resistor would be the minimum (brown-black-red)
a 1.2 k ohm would be safer (brown red red)
|