Pump suggestions...
 

Hey Gang,...I picked up a GFO reactor that I want to run on my reef tank but I need a pump.

The reactor will be running externally and it is approx 4 ft from reactor back up to tank.

I need an external pump that will produce at least 90 Gph at a 4 ft head, preferably something with adjustable flow rate.

Price range is $60-70

Any suggestions are welcome.
Thanx
Blaine

Blaine why not just tap into your return line with a john guess fitting and power the reactor that way

what return line?

I'm running the reactor as its own closed loop.

I dont have a sump or canister filter

ahhhhhhhhhhhhhhhhhhhh

ok so take a maxi jet 400 and run it with RO line and attach a John guess fitting to it and there you go.

See,...I bought a Maxi-Jet 900. Where the connections attach to the motor is really flimsy. Every time I moved one of the 1/2" lines it would pop the top off. I was worried it would leak.

I was looking at the Mag Drive 250 Supreme but I dont think it has adjustable flow. Does that matter? The reactor is a Two Little Fishies 150 and it has a flow rate adjustment knob on the intake line.

Have a good browse through J&L's pump selection. They list fitting sizes and head pressures.

FYI, Mag drives create heat, even when run externally, and can be a bit noisy. But, they are less likely to leak than, say, a Quiet One run externally.

I don't have any advice for you on other brands the size you need.

I would look at the Ehiem compact line of pumps.... very good quality and adjustable......the 1000 or 2000 would probably fit the bill....

I was looking at the Eheim Universal 1048 Water Pump.

Any thoughts??

oh!....re-read everything and it sounds like you wanna run the pump externally.....if thats the case then the 1048 would be the one to go with(if you decide to go with an Ehiem)....I dont think the "compacts" are meant for external use....

For a pump to have adjustable flow it would have to be equipped with a variable frquency drive to control motor speed, they are expensive. Just put a ball valve after the discharge end of any pump you get and adjust the flow that way (very cheap). Never put the valve on the pump's intake side.