Need some advice on an ATO system
 

Pretty new to reefing - 7 months now and constantly learning.
I have gone from a 29Gal up to a 90 Gal that I have to keep adding water to almost every other day.
I would like to have an Automatic Top off system for the tank but it is way to far from any water source.
I was thinking of having a large barrel close by the tank that I could keep full and would top off my sump when it get's below a certain level...
Any ideas on what I would need and how to do something like this without flooding my finished basement?
Thanks,
Steve'o

I bought a Reef Keeper lite and the float switch kit with it. Not only it an ATO but a controller. Much easier having everything on the head unit not having to worry about the power going out and having to reset the timers for lights ect.

I set the reservoir above my sump (to make sure there was no syphon) placed some rigid tubing at the bottom of the reservoir. Then connected some flexible tubing to the rigid tubing and to a aqua lifter. The aqua lifter is then turned on when ever the float switch is tripped, and turns off when water is back to normal height. Works very well. And not much more than the more expensive ATO's you will find on the market.

You will be given many options by others. I myself, dont' fool around and use the Tunze ATO. A little expensive, but well worth it.

I use the Tunze Osmolator as well. It's the only one I trust. I keep a 5 gallon pail near the tank which the Osmolator pumps out of.

We need an ATO sticky lol. New reefers open it up and it just says "buy a tunze. word."

I use one of these. Aside from having to clean the feather dusters off of it from time to time the thing appears to be bomb proof. Had mine going for over two years now. I liked it so much I bought a backup unit just in case.

If you can find float switches locally you can make your own quite easily. I was lazy so just bought this pre-made one instead. The second cut-off float is handy too in case the first one fails.

Agreed! I think this is the third time in the last week that this question has been asked. :lol:

Its funny, people complain about the costs of the higher units like Tunze... But then really complain or quit this hobby when their DIY ATO project fails and damages the house.

Personally the $200 bucks for the Tunze is worth it. Has never failed for me, and don't want to flood the house from top up... Now a tank burst is a different issue.

All too true! There should be no messin around when it comes to ATOs.

I'm a Tunze fanboy (Stream and Osmolator divisions) but even I'll admit I've read plenty of threads over at RC where users have issues with the pumps or sensors.

I bought one used previously and it worked well so I bought a new one for this tank. Heck I even submerged the controller accidentally in water and it's rock-solid.