Need Some help Please
 

I'm fairly new to Saltwater and have a 28 Gal Nano cube that I am running.
I purchased a used tank 90 Gal and with a stand, sump, pump all piping from a canreef user in Edmonton.
I'm just getting it setup now..
I'm not quite sure if I am doing the sump correctly and just wondered if there was someone in my area (Okotoks) that could drop by and tell me I am doing ok?
Don't really want to start adding water till I know I have this right?
any help?
thanks all
Steve'o

Can you post pics?

Here are some ideas and suggestions
- test the system with water someplace safe like a garage or unfinished basement
- verify no floods occur when the power fails or when a pipe is obstructed
- post pics and details on the type of overflow for more help with avoiding floods
- ensure the stand is both flat and level
- have drip loops and install GFCI outlets

Good luck with the tank.

Moving to the main reef forum for you. Should get more replies there.

check this site out....then ask your questions

http://www.melevsreef.com/tanks.html