Plexiglass glue
 

I had an "accident" after setting up my new protein skimmer that caused a bit of an explosion! Luckily, nothing cracked but the adhesive seal holding a plexiglass panel in place broke (too much water pressure). I since realized where I erred and am ready to give it another shot. The only thing I have to do first is re-glue the plexiglass panel. A product called weld-on 16 was recommended but I can't find it anywhere at any hardware store. I went to Home Depot and there were several different types of glues but I wasn't sure which one to use as an alternative. Any ideas anyone? Also, is this something that should be done by a professional and if so, can anyone recommend someone?

they sell it at Plasticworks in Surrey on 132 around 80 ave. google and check their website for address

If you go to plastiworks, make sure you ask for a few scrap pieces to practice on. scraps should be free to very cheap. gluing acrylic isn't really hard, but you should practice first if you need it water/airtight. and look up how to do it properly online before you start too.

Thanks everyone! I took it to plasticworks and they are going to do it for me for $10-15 bucks! An excellent resource for aquarium enthusiasts.

Thanks again.