Profilux digital power bar.
 

I am looking to repair or replace one of my Profilux power bars. I noticed the other day that my calcium reactor was not running and on further inspection found that the entire power bar was randomly turning the 6 outlets off and on. I attempted to reprogram all of the outlets but it continued to act up. Has any one had this same problem and if so how did you fix it.
Thanks in advance.
Keith.
If it can't be fixed i will be looking for a replacement.

Try posting your problem on RC. The GHL site is monitored their.

Tom R

Hi

This can be two things

1. interference caused most likely by ballasts close to the power bar
2. water damage.
3 damage to data cable

1. Please check location of high voltage items to the power bar control line

2. If the power bar has been subject to high humidity or water incursion all manner of things can go astray.

3. Check the integraty of the data cable.

New PCB's are available cheapily.

Power bar
 

Thanks for the replys guys.
Come to think of it I did just move one of my ballasts to within about a foot and a half of where the power bar was mounted.
Will moving the ballast return things to normal?
Thanks for the help!
Keith.

Possibly you would have to try it to find out.

Let me know