Nano Wall Mount Project Idea
 

Just found this tank says it 6.6 Gal could be a fun project for someone.

A wall mounted Nano.

http://www.canreef.com/vbulletin/pic...&pictureid=776

http://www.aquavistainc.com/home.html

interesting idea, but I doubt it would last very long as a thriving tank.

There's a thread somewhere on RC where they took a tank and made it look like it was on the wall. Very interesting design and outcome.

These tanks just seem too thin to even bother I think

I had two wall tanks very similar to those. They were 4" wide and about 36" long. If I remember correctly they held about 10 gallons. I had small freshwater fish and plants in them.. guppies mostly.
They were horrible tanks!

4" wide you can barely get your hand into and they were a nightmare to clean. They were pretty expensive and a total waste of money. They have been sitting in my storage room for years.

Nano Wall Mount
 

My daughter has one and I have one in my office. They are small but OK for small FW set up. I think they would be useless for SW. With the FW they are fine..ours have been up for 2 years. Only disaster was when someone unplugged it and it got cold!

There's one of those at one of the local stores here. It's one of their display tanks behind the cash with a pair of clowns.