![]() |
Cleaning with Vinegar
So I always hear everyone seems to clean their equipment with vinegar, so I figure I need to quite being lazy and at least clean my powerheads (maybe the next big step will be my return pump after that. So my question is how much vinegar do you guys mix with water, and do you then just put the equipment in there for a certain amount of time and rinse or is there more to it?
|
I use about a cup or two of vinegar to a half gallon of water, more if I'm in a hurry. I usually get impatient and scrub the stuff, but if you leave it long enough, the coraline will come off on it's own, assuming there isn't enough to neutralize the vinegar.
|
Good to know, being lazy myself I'm gonna use more and hopefully the coralline just comes off.
Thanks Brad for the response. |
Let it sit for an hour or two and it should come right off, no scrubbing required.
|
I find using warm, but not hot water works best as well. It just seems to soften up coraline, but not remove it when the water is really hot.
|
I use about a 10 to 1 ratio of water to vinegar and let it soak overnight, after that you just rinse it off, hardly any scrubbing.
|
Quote:
Steve |
Quote:
Steve, I understand that pure vinegar could eventually damage seals(rubber ones, not furry ones), oe was it bleach? Either way, I don't use pure vinegar because of this, and hell, it's 3 bucks a jug! :) |
I use a 50/50 water & vinegar mix. I reuse it about 3 times before I throw it out.
|
Vinegar is pretty cheap at COSTCO. You get 2 hugh bottles for $3 or $4.
Tom R |
All times are GMT. The time now is 10:38 AM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.