Looking for info.
 

Ok, have a couple of requests here.

1 - Where in Surrey/Vancouver can I find acrylic:question:

2 – There was a calculator for thickness of glass in a tank.
Where is that again?

3 – Do you think an 8 gallon reef is too big for a desk? :wink:

Thanks everybody.

acrylic
 

I believe there is a place called Industrial plastics and paints in langley that carries acrylic.Clint

http://www.plasticworks.ca/?gclid=CM...FSSmYAodZCCZqgthey're on 132nd
look for a various calculators on RC in the left hand column

I know about the ones on RC but can not find the one for calculating the thickness.
Want to run an 8 G - 24 X 10 X 8

GE Polymer Shapes. In Coquitlam, sort of under the Port Mann. You can find thier address an canada 411. Half the price of the industrial plastics out here. They will ship if you don't have time to drive. These days, it will likely cost the same to ship as to drive over the bridge in traffic. GARF has a good acrylic calculator.

Aquarium Height Sheet Thickness
1 to 12 inches 1/4 inch
12 - 18 inches 3/8 inch
18 - 24 inches 1/2 inch
24 - 30 inches 3/4 inch

For tanks up to 8ft in length

from here http://www.cichlid-forum.com/article...c_aquarium.php

As per Mapquest. Less than 10 min drive. Thanks.
Now to figure out how thick a piece I need...:lol:

Beautiful, thanks.