Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   DIY (http://www.canreef.com/vbulletin/forumdisplay.php?f=13)
-   -   Auto top-off failsafe (http://www.canreef.com/vbulletin/showthread.php?t=34388)

kfowler 08-01-2007 05:53 PM

Auto top-off failsafe
 
I'm looking for some protection against overfilling my tank with RO water.

Currently I have my Aquasafe RO/DI unit plumbed directly into my sump, which is controlled with a Kent float valve. The RO unit has a built in shut-off kit so the unit isn't pumping water down the drain while the unit isn't in use.

My worry is that if the float valve is stuck in the "open" position and fills my tank with fresh RO water, killing my tank, and flooding my house.

I would like to rig in some type of sensor/actuator that senses this overfilled condition and shuts off the water entering my tank. Does anyone have anything like this in their setups?

Any help would be appreciated.

mr_alberta 08-01-2007 09:35 PM

You need a solenoid hooked up to a float valve (or two). That's what I used to use. Worked like a charm. I picked up the solenoid back in the day online from McMaster-Carr, but, sadly, they have since stopped shipping to Canada.

kfowler 08-01-2007 10:16 PM

Do you know where I could pick up a similar setup to what you used?

I saw this online, which would work I think depending on how sensitive the strip sensor was.

http://www.camarillowaterstore.com/item140170.ctlg


All times are GMT. The time now is 12:40 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.