help with my remora pro skimmer
 

So after hours of draining water, moving the tank out from wall, we put the skimmer on back of the tank & it did not fit so hubby cut the plastic.

ok in place I adjusted the knob in box and plugged in,

well the skimmer filled and did not stop filling up.
please help, I have adjusted the rubber ring on box and it still fills.

any suggestions or help

now i have this great skimmer that is off atm , so I put my old remora back on but hanging off the front!

tia
Connie

as far as i know the valve inside the skimmer doesnt need adjusting. My remora pro went nuts with aqua plus conditioner, would fill up a few times in a couple hours. try adjusting the box as high as it will go with the ring and then lower it after a few hours- see what happens then

neil,do you think this is ti high

seems to be not over flowing as fast now.
http://img107.imageshack.us/img107/4...53smallsv6.jpg

no-if its too high it will fall off ;). it is just a little noisey the higher it is, but it might be just reacting to something in the water. leave it high until things seem to settle down a bit.

remora's take a little while to break in fully (up to 1 month) and will work like a charm afterwards. One of the best hob skimmers out there if not the best as long as you wait for that break-in period.

any luck there connie? do you use water conditioners? looks like it sits snugly behind that canopy. You should see my new DIY stand

ya it is working now, with out a river on the floor!


now the pump is making weird rattling( like a loose impeller) so i may need a new mag3.

or impeller anyone know where to get a new impeller for the pump?

thx neal

what pita this has been all to upgrade my skimmer!