Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   DIY (http://www.canreef.com/vbulletin/forumdisplay.php?f=13)
-   -   RO/DI solenoid, where to buy? (http://www.canreef.com/vbulletin/showthread.php?t=27445)

kwirky 10-05-2006 05:40 PM

RO/DI solenoid, where to buy?
 
Anyone know where to buy just a solenoid for an RO/DI system? J&L sells the kits with the float valve, but I just want the solenoid.

I plan on doing top off using a solenoid and an electronic timer, following this design:

http://www.esopenko.com/images/aquar...15kreactor.jpg
designed by calvin415 on nano-reef.com
original post: http://www.nano-reef.com/forums/inde...st=0&p=645353&

I'm going to scale it by using a whole house filter, rather than a single RO prefilter chamber. I'm probably going to put a little pump inside too, since I suspect the RO won't be able to keep THAT much kalk mixed.

But good auto top off units are quite pricey, so I'm planning to run the system on a solenoid with an electronic timer. Time it so that it JUST under-tops the tank. Where it stands, my 120g system only goes through about 3-4 gallons of evaporated water daily, so I think running the unit for like 1.5 hours a day would work well.

Any suggestions where I could buy the solenoid solo? Preferably in Calgary if possible.

Delphinus 10-05-2006 05:58 PM

What about using an irrigation valve on the RO input side? (I think they're about $20 at Home Depot). I think they use 24VDC so if you could find a power supply (Princess Auto would have them), all you'd need is the timer and you're set.

kwirky 10-05-2006 06:20 PM

thanks for the advice :)

anyone have experience in getting whole house filters cheaper than at home depot?

Psyire 10-05-2006 10:04 PM

www.autotopoff.com


All times are GMT. The time now is 01:37 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.