wiring a Iwaki mx-100
 

Hey peoples........
I just got a new mx-100 Iwaki and yes @#$##$ no power cord. Could you give me some help wiring it please. I will be using 30 amp cord, took off the power box cover found the ground marked G...lol , but the poss and neg I dont want to mess up.

Thanks

If there is white and black terminal then use black for hot lead (smaller one in the receptacle) and white for neutral. There is no positive & negative it's alternating current.
If it's not marked then it don't matter witch way it goes.
You can always check iwaki web.
http://www.iwakiwalchem.com/nav/cm.aspx?cmid=35

Well After looking at the web myself, no help there.
Why don't you take a pic of the connector and we can try to figure it out for ya.
It appears that these are a industrial hard wire application pumps, hence no cord. Manual just says wire accordingly to elec. code.

I think I got it.......

Thanx for your help